The power injector combines 55-VDC power (supplied by internal power supply) with the data signal, sending both to the access point. The power injector provides up to 60 W over all four wire pairs of shielded, outdoor rated Ethernet cable.
The total length of the Ethernet cable from the AP to the switch must not exceed 320 ft (100 m). The wire gauge of the cable must be 26 AWG.
The Ethernet cable from the switch to the power injector must be a shielded CAT5e or higher Ethernet cable. The Ethernet cable from the power injector to the access point must be a shielded outdoor-rated CAT5e or higher Ethernet cable with a 0.20 to 0.35 inch diameter. A shielded, outdoor Ethernet cable connects the power injector to a 10/100/1000 Ethernet switch, hub, or network, and another shielded, outdoor cable carries power and data to the access point's Ethernet port. The power injector's AC power receptacle connects an approved AC power cord to a wall outlet or power strip.The power injector can be mounted on most horizontal and vertical surfaces, but must be mounted in a vertical orientation to comply with safety requirements. Compatibility Cisco Aironet 1560 Series Outdoor Access Points. Input Voltage: 120 V AC, 230 V AC. Maximum Output Power: 60 W.
Maximum Output Voltage: 55 V DC. Weight (Approximate): 2.98 lb.
You are purchasing a product designed for use in North America. The power and transmission requirements may be different then in your local country, please make sure to follow all applicable use and safety regulations.Government and shipper regulations prohibit such behavior. We may no longer be able to change or cancel your order. Please excuse any image and typographical errors. The item "NEW Cisco AIR-PWRINJ-60RGD1= Aironet PoE Injector Power 60W Outdoor NA" is in sale since Monday, April 5, 2021.
This item is in the category "Computers/Tablets & Networking\Enterprise Networking, Servers\Other Enterprise Networking". The seller is "targetpcinc" and is located in Willoughby, Ohio. This item can be shipped worldwide.